Dishwasher displays error code i40
Issue
- Dishwasher displays error code i40
- Dishwasher emits 4 beeps / 4 flashes
Applies to
- Dishwasher
Solution
1. Reset your appliance.
Remove the plug for the dishwasher and plug it in again after app. 5 minutes.
2. Check your dishwasher filter and sump (see the instructional video below) for signs of foam/suds & debris
How To Clean Your Dishwasher Filter
- Make sure you clean all the filters
- Clear any foam/suds from the sump
- Plug the appliance back in. Turn on the dishwasher, select a suitable cycle and start it.
- If the cycle starts and operates normally, the problem has been resolved.
If the above steps don't resolve the issue, we recommend contacting an Authorized Service Center.
Was this article helpful?
Related Articles
- Dishwasher displays error code i30
- Dishwasher short-circuits, burns out fuses or trips RCD circuit breakers
- Dishwasher does not switch on, no light on the control panel
- Electrolux Dishwasher does not dry or dries poorly
- How to load and unload the dishwasher?
- Dishwasher not cleaning properly
- Dishwasher displays error code i10, i11 beeps once, or the warning light flashes once
- Program not starting and cycle indicator light flashing on dishwasher
- Water is flowing back into the dishwasher
- Dishwasher comfort lift basket stuck in the UPPER position