Westinghouse Air Conditioner - How to use the Remote Controller
Issue
How to use the Remote Controller
Applies to
- Westinghouse Split System Air Conditioner
Solution
How to use the Remote Controller
1. Keep the remote controller where its signal can reach the receiver of the
indoor unit.
2. When operate the air conditioner, make sure the remote controller is pointing to
the signal receiver of the indoor unit.
3. When the remote controller sends out a signal, the symbol will blink in the
display of the remote controller.
4. The indoor unit will acknowledge the signal with a beep sound when it
receives the signal from the remote controller.
5. Please press the button of the remote controller and resend the signal if you
did not hear a beep sound from the indoor unit.
Location of the Remote Controller
Keep the remote controller where its signal can reach the receiver of the indoor unit (a maximum distance of 8 m is allowed).
Battery Installation /Replacement
- When changing batteries, do not use old or varied ones, otherwise, it may cause
problems with the remote controller. - If the remote controller is not used for a long time, remove the batteries as old batteries may leak or corrode and damage the remote controller.
The battery life during normal use is about six months. - If the remote controller does not operate normally, please remove and refit the batteries If abnormal operation continues, replace with new batteries.
Note:
- The air conditioner will not operate if curtains, doors or other materials block the signals from the remote controller to the indoor unit.
- Prevent any liquid from falling into the remote controller. Do not expose the remote controller to direct sunlight or heat.
- If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not function properly. Use curtains to prevent the receiver being exposed to sunlight.
- If other electrical appliances react to the remote controller, either move these appliances or consult your local dealer.
For a complete description of all remote functions, please refer to the user manual