After a short power failure, Demo appears on the display and my oven will not heat up - Electrolux

Issue

After a short power failure, Demo appears on the display and my oven will not heat up.

• After power failure or after the fuse has been taken out, the display shows Demo without setting the demo mode manually.
• The heating setting, the temperature setting or other settings can be set, but the oven does not heat up.

Applies to

• Built-in oven
• Compact Oven

Solution

Deactivate DEMO Mode

Please ensure you are following the correct instructions for your oven display

Ovens with a TFT Touchscreen Control

1. Press: Menu

2. Select Submenu for Service

3. Select - Demo mode ‘deactivate’ Off

Activation / deactivation code: 2468 Press OK

1. Select menu – Settings Press OK

2. Select menu setting 09 – Demo Mode Press OK

3. Adjust the value to select and confirm each number of the deactivation code.

- Deactivation/Activation Code 2468

1. Ensure the oven is in the off state.

Toggle and hold the selector to + until a beep sounds. The ‘DEMO’ text will begin to flash.

2. Toggle the temperature selector to set the first digit of display to 2.

Touch clock to set.

3. Repeat step 2 until display shows 24:68. 3 beeps sound and DEMO will be disabled

4. To disable, enable DEMO mode repeat steps 1 - 3.

1. Ensure the oven is off by touching the ON/OFF symbol.

2. Touch and hold the ON/OFF symbol until the display turns ON then OFF.

Immediately after, touch both the 'cooktime' + and - symbols simultaneously. Hold until a triple beep sounds.

1. Ensure the oven is in the off state. Press and hold the + button until a beep sounds. The ‘Demo’ text will begin to flash.

2. While holding the + button turn the function selector to the first oven function until another beep is heard.

3. Then turn the function selector to the ‘off’ position.

4. Release the + button.

5. Toggle and hold the temperature selector to the right (+) until 3 beeps sound.