Error PF - Dishwasher cycle stopped and or won't start
Issue
Error PF displayed the program selection bar
Applies to
- Dishwasher
Solution
Error Code - PF
Possible cause
Power supply is out of the operating range. The wash cycle is temporarily interrupted and resumes automatically once the power is restored.
- The electronic board makes sure the dishwasher operates within certain voltage limits. If during the cycle the voltage is outside the limits, the electronic board suspends all loads and interrupts the cycle. The ‘PF’ alarm is triggered.
- The lowest main voltage threshold is 173 Volt and the highest is 278 Volt.
- If the supply voltage goes back within the limits, the electronic board cancels the error status and the cycle resumes.
Was this article helpful?
Related Articles
- Dishwasher displays error code i30
- Dishwasher short-circuits, burns out fuses or trips RCD circuit breakers
- Dishwasher does not switch on, no light on the control panel
- Electrolux Dishwasher does not dry or dries poorly
- How to load and unload the dishwasher?
- Dishwasher not cleaning properly
- Dishwasher displays error code i10, i11 beeps once, or the warning light flashes once
- Program not starting and cycle indicator light flashing on dishwasher
- Water is flowing back into the dishwasher
- Dishwasher comfort lift basket stuck in the UPPER position
In Warranty Service & Repair
Need to arrange a repair technician visit? Repairs under warranty are free of charge and we are here to support you after your warranty has expired. Authorised Technicians and genuine parts for complete peace of mind.